[Konvas] Kinor 35H lubrication guide?

[Camak, Lael (US - MGTTS)]

Hey guys, 

Its probably your main bearing seizing up.  Electronics will be fine,
motor will turn fine, but once assembled it is metal against metal in
the Kinor's design (for the end of the shaft from the motor).

Anders Banke has a awesome manual on lubing this.  He put a lot of
effort into it with great pics and documentation.  It even details two
different type Kinor design.  It is a must have.  I donated $50 via
paypal to him for it.  I think he should be rewarded for his work and it
saved me in the middle of an indie shoot.  

I have it, but I don't feel I can post it, because it reflects a
considerable amount of knowledge and work that one should expect to pay
for.  I think donations in the amount of $35-$50 would be reasonable.

I posted this info before when I was having this problem.  I'd contact
Anders.  And no, I get nothing for it. 

Lael  


This email may contain proprietary information and/or copyright
material. This email is intended for the use of the addressee only.
Any unauthorized use may be unlawful. If you receive this email by
mistake, please advise the sender immediately by using the reply
facility in your email software.

Information contained in and/or attached to this document may be
subject to export control regulations of the European Community, USA,
or other countries. Each recipient of this document is responsible to
ensure that usage and/or transfer of any information contained in
this document complies with all relevant export control regulations.
If you are in any doubt about the export control restrictions that
apply to this information, please contact the sender immediately.

Be aware that Meggitt may monitor incoming and outgoing emails to
ensure compliance with the Meggitt IT User policy.