[Konvas] Kinor 35H lubrication guide?

[Camak, Lael (US - MGTTS)]

It could still be the main bearing.  Have you lubed it?  Even though
your camera frees up after the movement is removed, it coulds till be
the bearing.  The movement when properly working will create friction /
pressure back on that main bearing.   
When I took mine apart and lubed my bearing, the bearing didn't look
like it needed any lubrication.  But that was indeed the problem.
Smooth as silk after that.

I hope you sort it out.  If you are starting to get into that double
gear you are braver than me.  That's when I'd send it to a professional.

All the best, 
lael 



This email may contain proprietary information and/or copyright
material. This email is intended for the use of the addressee only.
Any unauthorized use may be unlawful. If you receive this email by
mistake, please advise the sender immediately by using the reply
facility in your email software.

Information contained in and/or attached to this document may be
subject to export control regulations of the European Community, USA,
or other countries. Each recipient of this document is responsible to
ensure that usage and/or transfer of any information contained in
this document complies with all relevant export control regulations.
If you are in any doubt about the export control restrictions that
apply to this information, please contact the sender immediately.

Be aware that Meggitt may monitor incoming and outgoing emails to
ensure compliance with the Meggitt IT User policy.